RF power amplifier

src: upload.wikimedia.org

A radio frequency power amplifier (RF power amplifier) is a type of electronic amplifier that converts a low-power radio-frequency signal into a higher power signal. Typically, RF power amplifiers drive the antenna of a transmitter. Design goals often include gain, power output, bandwidth, power efficiency, linearity (low signal compression at rated output), input and output impedance matching, and heat dissipation.

Video RF power amplifier

Amplifier classes

Many modern RF amplifiers operate in different modes, called "classes", to help achieve different design goals. Some classes are class A, class B, class C and class E. There is a Class D, but those amplifiers can work only with low frequency signals typically used in audio equipment.

Maps RF power amplifier

Solid state vs. vacuum tube amplifiers

Modern RF power amplifiers use solid-state devices such as bipolar junction transistors and MOSFETs. Transistors and other modern solid-state devices have replaced vacuum tubes in most electronic devices, but tubes are still used in some high-power transmitters (see Valve RF amplifier). Although mechanically robust, transistors are electrically fragile - they are easilly damaged by excess voltage or current. Tubes are mechanically fragile, but electrically robust - they can handle remarkably high electrical overloads without appreciable damage.

src: electronics-diy.com

Applications

The basic applications of the RF power amplifier include driving to another high power source, driving a transmitting antenna and exciting microwave cavity resonators. Among these applications, driving transmitter antennas is most well known. The transmitter-receivers are used not only for voice and data communication but also for weather sensing (in the form of a radar).

src: i.ytimg.com

Wideband amplifier design

Impedance transformations over large bandwidth are difficult to realize, thus most wideband amplifiers use 50 ? output loading. Transistor output power is then limited to

${\displaystyle P_{out}\leq {\frac {(V_{br}-V_{k})^{2}}{8Z_{o}}}}$

${\displaystyle V_{br}}$ is defined as the breakdown voltage

${\displaystyle V_{k}}$ is defined as the knee voltage

and typically ${\displaystyle Z_{o}=50\Omega \,}$

The loadline method is often used in RF power amplifier design.

src: ae01.alicdn.com

References

src: www.qsl.net

External links

• Carlos Fuentes (October 2008). "Microwave Power Amplifier Fundamentals" (PDF). Retrieved 2013-03-05. 
• Khanifar, Ahmad. "RF Power Amplifier Design for Digital Predistortion". www.linamptech.com. Retrieved 1 December 2014. 

Source of article : Wikipedia